Many protective film use terminals, such as injection molding factories, glass processing, and touch screen manufacturers do not know the steps of peeling the protective film, which often causes unnecessary trouble when using the protective film and affects production efficiency.
We have produced protective films for up to 16 years. Not only do we have long-term and stable protective film production management experience, but also have accumulated a lot of protective film end-use experience. With the improvement of living standards, TVs, computers and other products have become quite popular, so Corresponding protective film products are becoming more and more popular. The role of the protective film here is to prevent the LCD screen from being destroyed, but also to facilitate the cleaning of the LCD screen.
Although everyone knows that you can stick a protective film on the LCD screen to protect it, but it is not known that the protective film can be cleaned in different ways. One is to use the special dust-removing stickers for the protective film to clean, which can not only play the role of cleaning the screen, but also cause damage to the protective film and the screen.
When operating, first put the dust removal sticker on the protective film, tear the dust removal sticker again, and stick it to the corner of the protective film. Press firmly on the dust remover to make it adhere to the protective film. Pull the film in the opposite direction, and the corner of the protective film will be pulled up immediately. At this time, you can paste the second piece of dust removal film in the adsorption layer of the protective film, corresponding to the location of the first dust removal sticker Remove the protective film.
After the cleaning is completed, paste the protective film again. Since the adsorption layer of the protective film is less protected by the release film, extreme care must be taken when re-pasting to avoid damage to the protective film.
Of course, the protective film can also be washed with water. Prepare a larger cup and put in pure water; then use a dust remover to remove the protective film from the screen and put the protective film in water to wash back and forth. Wash the protective film out of the water and place it in a cool place.
It is recommended to lean the protective film against the cup so that the adsorption layer of the protective film is downward, and the water drops can be reapplied after they are completely dried. It should be kept in mind that the protective film must be dried naturally after washing. Do not use a soft cloth to wipe the adsorption layer, otherwise it will stick to the dust. If you accidentally stick to the dust, you can repeat washing once.