Clean the aluminum spacers for use. Put the butyl hot-melt sealant into the extruder cylinder to preheat to 130-140 ℃, after the thermostat maintains the constant temperature, when the glue strip is printed to check the uniform line, apply the glue strip to the aluminum spacer groove, slightly After cooling, it is pressed into a semi-finished hollow glass product with clean glass. After the outer sealant is applied and cured, it is a finished hollow glass product. When using imported fast glue machine for production, the temperature of the rubber cylinder should be increased by 10-15 ° C, and the extrusion pressure should be adjusted from 150Mpa to 170-200Mpa, so that the rubber strips are uniform.
Precautions: When taking butyl hot-melt sealant, the hands must be cleaned. The surface of the glue should not be dust, oil and solvents (such as acetone, gasoline, etc.). You can wear gloves that do not lose hair when applying glue. Be careful of burns when touching the hot glue. Gloves that touch the glue should be clean and free of burrs or other contaminants that can easily stick to the glue. When butyl hot melt sealant is glued, it should be controlled below 160 ℃, and it is strictly forbidden to glue above 170 ℃ to avoid aging and decomposition of the glue.
In addition, this product should be stored in a cool and dry place, to avoid the sun, rain, away from heat and fire; do not stress it; the storage period is two years. This product can be transported as general chemical products.