2. After the high-speed punching machine is finished, and after normal stamping, close the soundproof box (except for the 8065 side inspection side packaging of the product).
3. During continuous punching, employees cannot take the product with their hands within 1M of the punching machine.
4. When the technician is on the mold and adjust the machine, only one person can debug, not two people to debug.
5. The technician can adjust the machine and feed the material, only outside the machine, and the distance is not less than 1M.
6. Be sure to tighten the screws when setting up the mold, and stop the machine for 4 hours to check if the screws are loose.
7. When there is a problem in the production process of the mold, it is not necessary to remove the mold. When the mold is directly repaired on the machine tool, the power supply of the injection molding machine must be turned off and the repairing sign is hung on the power box before the mold repair can be implemented.
8. All tools are returned to the tool box after use, and can not be placed on the machine table to prevent the tools from slipping and hurting people.
9. When the machine is not in production, cut off the power supply in time.
10. For short and small workpieces, special tools should be used instead of feeding or picking up the parts directly by hand.
11. The producer should stand properly, keep his hands and head at a certain distance from the punch, and always pay attention to the punch, and chat with others is strictly prohibited.
12. Operators and mold repairers are strictly prohibited from reaching into the mold during production.
13. When installing the suction fan, the operator is strictly forbidden to reach out to the motor to clean up waste.
14. It is strictly forbidden to wear slippers when going to work, so as not to hit your feet with molds and iron blocks in the workshop. Monitors, fitters, and mold repairers must wear protective shoes when going to work;
15. It is strictly forbidden for male operators to wear long hair, and for female operators, long hair should be coiled up to prevent long hair from getting caught in the flywheel.
16. Pay attention to fire prevention for other oils such as white electric oil, alcohol, cleaning agent and so on.
17. When packing materials, scraps and molds, please wear gloves to avoid scratching your hands.
18. When there is oil, it must be cleaned up in time to avoid slipping and falling.
19. It is strictly forbidden to wear gloves when drilling and milling machines; when using the grinder, wear a mask and eye protection to protect yourself.
20. Pay attention to drag the mold to prevent it from falling on the ground (you must put the flatbed cart to the lowest to pull the mold).
21. It is strictly forbidden for non-electricians to connect to electricity and repair the machine.
22. It is strictly forbidden to blow the wind gun at people, which can easily hurt the eyes.
23. The operator needs to wear earplugs.