(1) Pruning of long fruiting branches: long fruiting branches that grow in various parts can be kept, and densely growing long fruiting branches can be thinned out and standing upright, leaving flat and oblique ones. Long fruiting branches can be put on long or lightly cut, and new shoots are drawn at the top of the branches. Few but gentle growth. After the branches are bent in the middle and front part, the branches are easy to grow branches at the back. The long fruit branches are cut in the middle, the growing branches are easy to shoot near the cutting mouth, and the middle and short branches occur in the back. The long fruit branches are short, and the main branches are growing. On the seedlings, in the long fruit branches, it is not easy to set fruit after heavy short cut, especially in the early stage of fruiting. Long fruit branches are excellent fruiting branches for seedlings, which can not only produce high-quality fruits, but also renew themselves. Pay attention to keeping more such branches when pruning.
(2) Pruning of middle fruit branches: The pruning method of middle fruit branches is basically the same as that of long fruit branches. Unless it is used as a preliminary branch, it is generally not short-cut, and the pruning response is similar to that of a long fruit branch.
(3) Pruning of short fruit branches: Short fruit branches can leave 3 groups of flower buds short cut, but the cut must be leaf buds. If there are no lateral leaf buds on the short fruit branches, they cannot be short cut. In the short fruit branches, more branches can germinate and disperse nutrients, and the growth of each new shoot is not strong, especially the lower buds far from the cutting mouth, the germinated branches are shorter, because the short branches stop growing early and accumulate nutrients More, enhance the growth potential of mother branches. The short fruit branches are left with 1 to 2 leaf buds at the base and re-cut as preliminary branches.
(4) Pruning of bouquet-like fruiting branches: only thin out dense branches, not short cuts.
(5) Pruning of extra-long fruiting branches: This kind of branches often grows vigorously and consumes a lot of nutrients, and the fruit setting is not firm. Sometimes although the fruit can be set, the fruit is small and inferior in quality, so the fruit is generally not used. This branch is mostly born in the inner chamber or near the top of the crown. The lower part of the branch is mostly leaf buds, and only the upper part has a few flower buds. However, good fruiting branches can be formed after modification. The transformation method is to re-cut in winter and topping in summer. Such branches can also be transformed into branch groups or used for renewal.
Seedlings are dominated by long and middle fruiting branches, and the remaining fruiting branches should be sparse. Generally, after pruning, the branches of the fruiting branches should be kept above 20 cm, and the long branches on the same side of each branch of the young tree should be kept about 40 cm.