Use and troubleshooting of spray booth:
I. Working principle: After the paint spraying station is powered on, the control system works, the suction pump and the axial fan run; the paint mist generated by spraying is filtered through four "S" water curtains to achieve purification purposes; the exhaust gas is discharged by the fan to the outside.
Adjustment and use
1. After the spray booth is placed in the best position, connect the power supply, and connect the chassis to the safety ground.
2. Put water into the water tank, and the water position is more than 80% of the water tank.
3. Close the power switch, the power indicator light is on, press the start button to check whether the water screen of the water plate is uniform, and it can be adjusted by reeling at the bottom of the water tank; the filtered water behind the spray table will pass through the "S" type water plate from the rear cover. The board overflowed and flowed into the water tank through the small hole (a normal phenomenon). The direction of the fan runs in the direction of the arrow, and the diameter of the flue cannot be smaller than the diameter of the fan, otherwise it will hinder the suction effect.