It is well known that wood crusher equipment is a device that specializes in crushing and processing wood into sawdust, but if the selected material is too wet, it will reduce production efficiency and affect yield, so in order not to affect yield, we target wet wood How should raw materials be handled? Let ’s follow Lu Xiaobian to find out:
First of all, the moisture content of general wood materials is less than 13%. Under normal circumstances, it can be crushed if it is not very high, but once it exceeds the normal ratio, it will affect the output of the machine, so we deal with the problem The source is based on the humidity of the selected raw materials. We can dry the materials in an economical and economical way, and reduce the humidity of the materials by natural air-drying and sunlight. If you can't do the natural drying materials for some reasons, it is recommended You invest in a dryer. The normal process of crushing sawdust is drying, then crushing, and crushing. After that, the crushed material can be used to a greater extent according to actual needs. It is good to make charcoal and press into granules. The choice is mainly based on personal needs. Our suggestion is to choose an economic and environmentally friendly way to dry the wood. This can help you reduce a certain amount of expenses to a certain extent. If the actual situation does not allow it, then choose Drying treatment.
Solution to the high humidity of the material crushed by the wood crusher
Inside the wood raw material, the wet material contains a high fiber content, which will affect the machine's blades and hammers for pulverizing operations. Over time, it may also cause blockage of the screen and damage to the blade hammers; and dry wood The amount of fiber contained in the raw material is small, which will not pose a threat to hammers and blades, and the natural output will be able to keep up. This is the long-term work experience summarized by the front-line workers of Lusteel Machinery, so we hope that everyone will buy wood to be broken Before the machine solves the problem of the dryness and wetness of the material, so that the output will not be small in the subsequent production operations.