1. The buffer air cushion machine and the winding machine are the same because of the high power consumption, so the power input to the power supply is greater than the nominal power on the nameplate of the shrink machine, otherwise it is easy to burn the circuit or electrical components.
2. Like a baler, the machine is grounded reliably to protect the human body.
3. Each machine is delivered with a power cable when it leaves the factory. The lead wire on the end of the machine is identified by the power supply symbol. ** Correctly connected, illegal operation may cause electric shock.
4. When the specified voltage of the machine is a three-phase 380V power supply, ** simultaneously input the neutral line, that is, the standard three-phase four-wire other packaging equipment is also like a vacuum packaging machine. Otherwise, the machine will not work properly, and the internal electrical components will be easily damaged.
5. The machine must be installed horizontally, otherwise the service life of the electric heating tube will be shortened. For mesh conveyors, oblique installation will cause the conveyor to be off-center.
6. When the machine is used continuously for more than three months, the temperature-resistant wire of the shrink chamber should be checked and replaced as appropriate according to its aging degree.
7. When the machine is working, the operator's palm and other parts are not allowed to contact the moving parts of the machine, especially the temperature inside the shrinkage room is extremely high, which is easy to burn.
8. After the packaging work is completed, the heating switch should be turned off first, and the conveying motor and fan motor should continue to run for about 10 minutes, and then the entire power supply is cut off.