PVC board wall panels are used to protect walls. It is a type of wall decoration material that has developed relatively fast in recent years. It maintains the cleanliness of our home walls for a long time and has a better decorative effect. Most of the wall panels use wood as the base material, but now PVC wall panels are occupying the market share, because of their high quality and low price, they are easy to clean. Today, I will introduce the construction steps of PVC wall panels.
1. Introduction to the basic situation of PVC wall panels
PVC board manufacturers introduce PVC is a kind of vinyl polymer, and its manufacturing material is an amorphous material. PVC wall panels have the characteristics of light weight, heat insulation, heat preservation, moisture-proof, flame-retardant, and easy construction. There are many specifications, colors, patterns, and very decorative. It can be applied to the decoration of indoor walls and ceilings. It is one of the decorative materials used in plastic materials.
2. Construction technology of PVC wall panels
1. Measure the wall surface. First measure the length of the wall panel to be installed, and cut the length of the aluminum alloy according to this size. According to the size of the wainscot, calculate the integer block of the wainscot needed, and the extra space can be completed with the wainscot.
2. Nail fixing holes on the intercepted aluminum alloy, drill holes on the wall according to the spacing of the holes on the P aluminum alloy, and fix the skirting hook on the wall with expansion screws or steel nails.
3. Install the top corner line, usually apply special glue on both sides of it, then stick it to the top corner, pull it apart for a few minutes, and then stick it tightly. In areas with high humidity, the two baseboards should be combined, and appropriate expansion joints must be left, especially in the corners where furniture is placed. Expansion joints should be considered more.
4. Install the wall panel, insert the wall panel into the skirting line from left to right, the starting block should be grooved from the corner to the corner. Install expansion screws or steel nails at a distance of 1.5cm from the top of the retaining wall board. Pay attention that the screws cannot expose the surface of the retaining wall board. Coat the special glue in the groove of the waistline and insert it on the concave and convex surface after a few minutes. The corner of the wall must be diagonally 45°.
5. Install rubber anti-collision strips on the aluminum alloy bayonet, and insert the left and right seals on the two ends of the wall panel, cut off the length of the PVC panel, cover the panel on the aluminum alloy, and complete the installation.
6. When the installation is over, the two edges of the corner need to be coated with special glue, stick it to the top corner, and then pull it apart for a while and then stick it tightly. This will increase the fastness of the wall panel and increase its service life.
