Radiation cross-linked polyethylene heat shrinkable tape is a polyethylene material treated with high-particle radiation. It is band-shaped on the outside. It is make up with hot melt adhesive on one side after bidirectional orientation.
Features
The product has good adhesive connection performance, resistance to acid and alkali corrosion, fast shrinkage, good sealing performance, wide application range, easy installation, fast and labor-saving, low preheating temperature of 50 degrees Celsius and so on.
More Detail
Application
1. Remove the rust, dirt, and oil stains at the joints, and the rust removal reaches the sd2 level specified in SYJ4007-86 "Specifications for Surface Treatment of Steel Before Painting".
2. The polyethylene layer in the overlapped part should be polished to a rough surface.
3. Preheat the fill part with a flame heater at about 80 ° C.
4. One end of the heat-radiation cross-linked polyethylene heat shrinkable tape with a rubber surface (150 mm wide) aligned with the middle of the patch, bonded to the patch and flattened and compacted, and the other end is heated to the rubber surface (150 mm wide) and overlapped at the head The overlap with the polyethylene layers at both ends shall not be less than 100 mm.
5.After heating the adhesive surface of the fixing sheet, it is bonded to the overlap of the heat shrink tape and compacted, and there is glue overflowing around.
6.Heat from the one end of the central ring of the fillet to the heat shrink band at the fillet, and there will be glue overflow on the end face.
7. Make up the mouth of the elbow and heat it while winding it. After the winding is completed, heat the heat shrinkable tape at the elbow until the glue overflows at the overlap.
Workshop
Service
The earliest manufacturer of insulation pipe, anti-corrosion pipe and steam pipe in China
Our company is a raw material production, product development, design, sales set in one-scale enterprises.
Our quality: pass ISO9001, ISO14001
Our price is competitive, as we are manufacturer, we are the source.
International advanced production equipment
FAQ
Q:What is your payment method?
A:We prefer to T/T 30% deposit payment in advance, 70% balance paid off before shipment.
Q:Can we make an small order?
A:Yes, we can accept small order, but there won't be discount.
Q:What is the lead time?
A:As usual, we will complete the delivery within 5-20 days after your order.
Q:Can I get some samples for testing before placing order?
A:Yes, we can provide you some free samples for your reference if you would like to bear the express cost.
Q:Can you make other sizes and packages for this product?
A:Yes, we can make other sizes as your requirement, normally our quotation will contain the common package, if you need your own packages, you'd better advise your requirement ahead of time for an accurate quote.
Packing And Shipping
